Applied Science and Convergence Technology 2025; 34(1): 27-30
Published online January 30, 2025
https://doi.org/10.5757/ASCT.2025.34.1.27
Copyright © The Korean Vacuum Society.
Jaehyeok Shin , Siyun Noh
, Seunghwan Jhee
, Sumin Kang
, Yumin Lee
, and Jin Soo Kim
∗
Department of Electronic and Information Materials Engineering, Division of Advanced Materials Engineering, Research Institute of Materials and Energy Science, and Research Center of Advanced Materials Development, Jeonbuk National University, Jeonju 54896, Republic of Korea
Correspondence to:kjinsoo@jbnu.ac.kr
This is an Open Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (https://creativecommons.org/licenses/by-nc-nd/4.0/) which permits non-commercial use, distribution and reproduction in any medium without alteration, provided that the original work is properly cited.
Herein, we report the dynamic characteristics of flexible photosensors fabricated with InN nanowires and graphene. To investigate the effect of the number of graphene layers on the response characteristics, the top graphene layer was set as a single layer, and the bottom graphene layers were varied from single to quadruple layers to fabricate flexible photosensors. The response and recovery times of the as-fabricated flexible photosensor, with the triple-layer bottom graphene, were measured to be 20.6 and 24.2 ms, respectively, at an optical pulse illumination frequency of 5 Hz. The cross-point percentage was calculated to be 48.9 %, indicating a low probability of distortion in the pulse signal. The response and recovery times calculated from an equivalent circuit model composed of capacitances and resistances are in good agreement with the measured values. The flexible photosensors with fast-response characteristics demonstrated in this study could contribute to the implementation of the light-fidelity systems.
Keywords: InN nanowire, Graphene, Flexible photosensor, Dynamic property